- Our Store
- >
- "THE BEST" Digital Controllers Available Anywhere
- >
- ULWD 5500 watt ripple 220 volt heater & tri clamp box
ULWD 5500 watt ripple 220 volt heater & tri clamp box
SKU:
ELEMENT-5500-Ripple
$274.99
$224.85
$224.85
On Sale
Unavailable
per item
If your boiler or kettle has a 2" tri clamp ferrule the installation of this heater couldn't be easier as all you need is a 2" tri clamp and a gasket, no drilling or welding required! This is a cost effective element for your kettle or boiler.
When used properly, per our instructions this heater and enclosure will automatically ground your boiler which is a BIG safety consideration.
INCLUDED:
This heater can be used with any 220 volt controller designed to handle 5500 watts. If you need cable longer than the 10 feet that comes on the heater please contact us and we'll make it for you.
Comparison Notes: Quite a few of you call to ask us what the difference is between the fold-back and the ULWD ripple heaters that we offer so we'll try to clear that up for you. First of all they are both 5500 watt elements so they will both work equally well and heat at the same output. The big difference is the fact that the ULWD ripple style element is a bit more forgiving should you accidentally abuse it, like powering it up before it's covered with mash (dry-fire). Ultra Low Watt Density elements are also a little more durable because of the extra surface area of the element itself. Because of this extra length the heat output is typically spread out to about 50 or so watts per square inch of surface area.
Designed by us, Hi Proof Products.
When used properly, per our instructions this heater and enclosure will automatically ground your boiler which is a BIG safety consideration.
INCLUDED:
- Enclosure equipped with 2" stainless steel Tri-Clamp ferrule.
- ULWD 5500 watt ripple heating element, installed, wired, and grounded.
- 10 feet flexible rubber covered 10/3 gauge wire.
- Wire gland strain relief.
- 30 amp male twist lock connector installed and wired.
- Plug wires will be labeled for proper installation.
- Connects with any 2" Tri-Clamp ferrule on your boiler or kettle.
This heater can be used with any 220 volt controller designed to handle 5500 watts. If you need cable longer than the 10 feet that comes on the heater please contact us and we'll make it for you.
Comparison Notes: Quite a few of you call to ask us what the difference is between the fold-back and the ULWD ripple heaters that we offer so we'll try to clear that up for you. First of all they are both 5500 watt elements so they will both work equally well and heat at the same output. The big difference is the fact that the ULWD ripple style element is a bit more forgiving should you accidentally abuse it, like powering it up before it's covered with mash (dry-fire). Ultra Low Watt Density elements are also a little more durable because of the extra surface area of the element itself. Because of this extra length the heat output is typically spread out to about 50 or so watts per square inch of surface area.
Designed by us, Hi Proof Products.